📏 Distance & Bearing Calculator

Click the start and end points on the map to instantly get the distance (Haversine great-circle) and bearing. Manual coordinate entry also supported.

🗺️ Measure by Clicking

🅰️ Click the start point

Presets:

✍️ Or enter coordinates manually

🅰️ Start

🅱️ End

📐 Method and accuracy

  • Distance is the great-circle distance from the Haversine formula, using a mean Earth radius of 6,371,000 m.
  • The bearing is the initial bearing at the start point: 0° is north, increasing clockwise. Over long distances the bearing keeps changing along the path.
  • Haversine assumes a perfect sphere. The real Earth is an oblate ellipsoid (WGS84), which produces the differences below.
RouteThis tool (Haversine)WGS84 ellipsoid (Vincenty)Difference
Seoul City Hall ↔ Busan City Hall325.111 km324.915 km196 m (0.06%)
Seoul City Hall ↔ Jeju City Hall454.020 km453.039 km982 m (0.22%)
Seoul City Hall ↔ Incheon City Hall27.002 km27.043 km40 m (0.15%)

This margin is fine for everyday use, but surveying or legal boundaries that need metre-level accuracy require an ellipsoidal geodesic calculation.

❓ Frequently asked questions

What is the Haversine formula?

It calculates the great-circle distance between two coordinates on Earth's surface, assuming a sphere of radius 6,371 km. Accuracy is within 0.5% — sufficient for general distance use cases.

What does the bearing mean?

The initial bearing from start to end point: 0°=North, 90°=East, 180°=South, 270°=West. The result also shows a 16-point compass label (e.g., NE, ESE).

Is this the same as road distance?

No — this is straight-line (great-circle) distance. Real road/flight/sea distance is usually longer. For driving directions, use the Kakao Maps link below the result.

How do I enter negative coordinates?

Southern hemisphere uses negative latitude, western hemisphere uses negative longitude. E.g., Sydney -33.86, 151.21 / NY 40.71, -74.01. Try the NY-LA preset on the page.

What unit is the distance shown in?

Under 1 km it shows meters; above, kilometers with 3 decimal places.

Can I use non-WGS84 coordinates?

This tool only accepts WGS84 decimal degrees. For KATEC/UTM-K, use the separate coordinate-converter tool first.